User Tools

Site Tools


MOX A - CPU module

The CPU module is the basic MOX module, which needs to be present in every MOX device. It contains the following:

  • ARMv8 A53 dual-core 1 GHz processor
  • 512MB/1GB memory, the capacity of which cannot be increased after purchase
  • Moxtet system bus for connecting other modules
  • 34-pin GPIO connector
  • SDIO bus for WiFi module connection
  • SD slot for microSD cards with a capacity of at least 4GB (max up to 2TB), and write/read speed of up to 104 MB/s
  • RJ-45 Ethernet port 1Gbps full duplex, 2 LEDs located on the cage.
  • Round power connector with internal diameter 2.1 mm, 12V, max 3.3A (parameters of the supplied source). Minus (negative) is on the outside connector, plus (positive) on the internal connector
  • USB 3.0 port
  • Fully programmable button, implicitly designed as an reset button.
  • Status LED.

All ports and interfaces support the maximum bit rate of the interfaces concerned, speeds are not shared with other interfaces. Module power consumption is between 2 and 3 watts.

Links to all MOX modules: